Skip to main content

Changes to Step #17

Edit by geneb

Edit approved by geneb

Before
After
Unchanged

Step Lines

[title] Installing the HE280 PCB Mount, Continued.
[* black] Insert the barrel fan blocker between the last two heat sink fins at the bottom of the hot end.
[* black] Install with the long leg of the blocker on the left (red arrow) and the short leg of the blocker on the right (blue arrow). You'll feel the blocker "snap" into place when it's properly seated.
-[* black] Attach the PCB to the HE280 PCB Mount using three #4 x 1/2" screws as shown.
+[* black] Attach the PCB to the HE280 PCB Mount using three #4 x 3/8" screws as shown.