Skip to main content

Changes to Step #9

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[* black] For this step you will need the small allen key and the thermistor cartridge.
+[* black] Loosen the black set screw using the allen key enough to slide the thermistor into the heating block.
+[* black] Insert the thermistor FULLY into the heating block. The thermistor should go in as far as seen in pic 2.
+[* black] Use the allen key to tighten the set screw to hold the thermistor in place. This screw only needs to be snug, do not over tighten so the thermistor does not get damaged.