Changes to Step #7
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| - | [* black] For this step you will need the hollow silicone wire tube. |
|---|---|
| - | [* black] Using a screwdriver, carefully widen one side of the tube. This will help the tube slide over the crimps easier. |
| + | [* black] Locate the heat sink and heat break from the parts you just dissembled in the previous step. |
| + | [* black] Screw the heat break into the heat sink into the side with multiple closer fins as shown in pic 2. |
| + | [* black] The heat break has 2 flats on it used to tighten it. Use a 5/16 wrench or an adjustable wrench and securely tighten the heat break to the heat sink. |
Image 1
Old Version
New Version
Image 2
Old Version
New Version
Image 3
No previous image
Added