Skip to main content

Changes to Step #6

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] Strip the red insulated wires the length of other half of the wire splice crimps.
-[* black] On the other half of the crimp, attach the red insulated wires with the crimpers.
+[* icon_note] The main body of the hotend will come finger tight. Do not use this as assembled.
+[* black] First remove the nozzle (should only be on finger tight when taken from the kit). Then unscrew the heater block. Finally unscrew the heat break. You should have 4 seperate pieces.
+[* black] You should have the body disassembled as shown in Pic 2.

Image 1

Old Version

New Version

Image 2

No previous image

Added