Skip to main content

Changes to Step #5

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] Using the crimpers, crimp the wire splices onto the legs of the heating cartridge as shown in the photo.
-[* icon_caution] Only crimp the half of the splice the legs of the heater cartridge are on , leaving the other side for the wires!
+[* black] Locate the red silicone tube from the kit. Cut this tube in half so you have 2 pieces of equal length.
+[* black] Use a screwdriver on one end of a tube to help open up one side. This will help get the tube over the crimps you just installed.
+[* black] Slide one tube on one of the wires and work it down over the crimps until fully seated near the heater cartridge. Repeat this process on the other leg of the heater. The previous 11mm and 7mm cut lengths will give a result as in Pic 3.
+[* black] Bend the leg of the cartridge so they are back in line with the cartridge. Pic 3 shows a fully prepped heater cartridge.

Image 1

Old Version

New Version

Image 2

No previous image

Added

Image 3

No previous image

Added