Skip to main content

Changes to Step #4

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

[title] Wiring the Heater Cartridge
-[* black] For this task you'll need the two non-insulated wire ferrules and a pair of wire crimpers..
-[* black] Line up the crimp with the legs of the heater cartridge and trim to the half length of the crimp on both legs of the heating cartridge.
+[* black] Locate the two red insulated wires in the kit and strip off the ends as shown in the first picture approximately as long as half the crimp. 7 mm works fine.
+[* black] Insert the wires into the crimps and as in the step before use your crimp tool or pliers to crush the other half of the crimp attaching the wires to the crimp securely.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Deleted