Changes to Step #2

Edit by Andy Oprisko —

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

[title] Installing the Heater Cartridge
-[* black] For this task you'll need the heater block and the heater cartridge.
-[* black] Insert the heater cartridge as shown, paying special attention to the orientation of the heater block and the position of the cartridge. Use your Philips screwdriver to tighten the screw on the bottom face of the heater block to lock the cartridge in place.
-[* black] Remove the two PTFE insulating tubes from the cartridge power leads.
+[* black] For this task you'll need the heater cartridge and crimps included in the kit.
+[* black] Cut the legs of the heating cartridge to 11 mm.
+[* black] Bend one leg of the cartridge 90 degrees away from the other leg. This will seperate them giving room to attach the crimp terminals.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Deleted