Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #65

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Perform Initial Power Up and Function Test
-[* black] Plug in the power cable to printer.
-[* black] Turn the printer on.
-[* black] The hot end should light up, as well as the status LEDs on the Duet board.
+[* black] Go Here next > [guide|94|SE300 Hotend Assembly guide]
+[* black] Install the SE300 hotend as shown in the picture. Snap on ball joints, install springs, and plug in bowden and whip connectors.
+[* black] Plug in the power cable to printer. Turn the printer on. The hot end should light up, as well as the status LEDs on the Duet board.
[* black] We will now move on to the initial connection and setup.
[* black] Go Here Next > [guide|89|Configuring Rostock Max v3.2]