Skip to main content

Changes to Step #51

Edit by Caleb Fairres

Edit approved by Caleb Fairres


Step Lines

+[title] EZR Panel
[* black] Install the EZR Struder as shown, using four M3 10mm screws to attach it to the motor, and two 6/32 1" bolts and nylon lock nuts to attach it to the side panel.
[* black] Slide the hobbed drive roller on the motor shaft. Align the curve of the gear teeth with the bearing in the EZR and tighten the set screw.
[* icon_caution] In this instance, do NOT align the set screw with the flat of the motor shaft. The flat does not go low enough to meet the set screw fully. Tighten the set screw on a blank area of the curve of the shaft.
[* black] You can now install the silver knob.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3