Changes to Step #39
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
[title] Starting Wiring Connections | |
[* black] Image one shows the common terminal locations on the Duet board. Please reference this when preparing for wire installations. | |
[* black] We will begin with the end-stop switches. You will need to install three pin KK terminal housings on each set of end stop wires. The wires will install in terminals 1 & 3. | |
[* black] You will then plug them into the Duet Board. You must ensure that you get the correct end-stop plugged in with the corresponding location on the Duet Board. If not we will run into issues during later setup. | |
- | [* black] You will then secure the end-stop wires with a cable tie. |
+ | [* black] You will then secure the end-stop wires with a cable tie. |