Changes to Step #39
Step Lines
- | [* black] Insert wisdom here. |
---|---|
+ | [title] Starting Wiring Connections |
+ | [* black] Image one shows the common terminal locations on the Duet board. Please reference this when preparing for wire installations. |
+ | [* black] We will begin with the end-stop switches. You will need to install three pin KK terminal housings on each set of end stop wires. The wires will install in terminals 1 & 3. |
+ | [* black] You will then plug them into the Duet Board. You must ensure that you get the correct end-stop plugged in with the corresponding location on the Duet Board. If not we will run into issues during later setup. |
+ | [* black] You will then secure the end-stop wires with a cable tie. Reference the third photo for the location of this cable tie. |
Image 1
Old Version
New Version
Image 2
Old Version
New Version
Image 3
No previous image
Added