Changes to Step #34
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
[title] Routing Belts | |
[* black] Rotate the stepper motor to the position shown in the photo. This location will give you the most available range of motion for tightening the belts after they are installed. | |
- | [* black] Route the belt as shown in the diagram on step |
+ | [* black] Route the belt as shown in the diagram on step 31 |
[* icon_caution] Be sure that the belt is not routed on the outside of the frame or carriage pieces! This will prevent motion. | |
[* black] To thread the belt ends into the carriage, use a wire tie or the cut-off from a wire tie to guide the belt up into the belt slot. | |
[* black] After you have threaded the belt into the carriage pull the belt end tight - you want to pull all the slack out of the belt. | |
[* black] Install the second belt clamp | |
[* black] You can trim excess belt, but leave approximately 1" past the belt clip. | |
[* black] Complete the routing process for the remaining two towers. |
Image 1
Old Version
New Version
Image 2
Old Version
New Version
Image 3
Deleted