Changes to Step #24

Edit by Caleb Fairres —

Edit approved by Caleb Fairres

Before
After
Unchanged

Step Lines

[title] Wiring Connections
[* black] Locate the yellow ring terminals
-[* black] You will crimp a yellow ring terminal on the red 12awg wire from the Z tower, and the black 12awg wire from the X tower.
+[* black] You will crimp a yellow ring terminal on the red 12awg wire from the Z tower, and the black 12awg wire from the Y tower.
[* black] These two wires should then be routed through the base to the power supply.
[* black] They will connect to vacant V+ (red wire) and the V- (black wire) terminals on the power supply using the screws provided with the power supply.
[* black] Locate the shorter length of 12awg red wire from your kit. Crimp the final yellow ring terminal on one end of this wire. It will connect to the V+ location indicated in the photo on the power supply.