Changes to Step #29
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| [title] Install 40mm Fan | |
| - | [* black] The 40mm fan gets installed under the Duet WiFi board using 2 zip ties and 2 o-rings. |
| + | [* black] The 40mm fan gets installed under the Duet WiFi board using (2) M3 22mm socket head bolts, (2) rubber o-rings, and (2) nylon lock nuts. |
| + | [* black] Be sure the fan is blowing UP toward where the board will be mounted. |
| [* black] The o-ring should be installed between the fan and the laser cut panel. | |
| - | [* black] Start with feeding the zip tie down through the hole in the corner of the fan, then through the o-ring and laser cut panel. Finally bring the zip tie back up through the adjacent hole and secure it. |
| - | [* black] Perform this operation on both corners to secure the fan. |