Skip to main content

Changes to Step #29

Edit by SeeMeCNC

Edit approved by SeeMeCNC


Step Lines

-[* black] Insert wisdom here.
+[title] Install 40mm Fan
+[* black] The 40mm fan gets installed under the Duet WiFi board using 2 zip ties and 2 o-rings.
+[* black] The o-ring should be installed between the fan and the laser cut panel.
+[* black] Start with feeding the zip tie down through the hole in the corner of the fan, then through the o-ring and laser cut panel. Finally bring the zip tie back up through the adjacent hole and secure it.
+[* black] Perform this operation on both corners to secure the fan.

Image 2

Old Version

New Version