Changes to Step #26
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
[title] Upper Assembly | |
[* black] We will now build up the upper assembly. You will need the motor mount assemblies you previously built and the upper assembly base plate. | |
- | [* black] The upper assembly base plate has laser cut engraving on it that reads "THIS SIDE DOWN". Be sure to put that face down against your work surface. |
+ | [* black] Install the timing pulleys on the motor shafts with the set screw up against the flat, as shown in the photo. |
+ | [* black] The upper assembly base plate has laser cut engraving on it that indicate the X, Y, and Z tower locations. Be sure to put that faced up towards you and away from your work surface. |
[* black] As you did with the base assembly, orient and install the motor mount assemblies. Secure with 6-32 x 1" screws. | |
[* black] Repeat the process to install the injection molded side panels. |