Skip to main content

Changes to this Step

Edit by SeeMeCNC

Edit approved by SeeMeCNC


Step Lines

-[* black] Insert wisdom here.
+[title] Base Assembly
+[* black] You will now install the 3 idler assembles on the base plate. These are the assembles WITHOUT the motors.
+[* black] Tabs in the plates of the assembly align with cutouts in the base plate. Press the assembly into these cutouts.
+[* black] You will secure each assembly with (2) 6-32 x 1" screws. This may be done easiest by cantilevering the base plate over the edge of a table. After you have all (6) screws started you can flip the assembly over and fully tighten.

Image 1

Old Version

New Version