Changes to Step #35
Step Lines
+ | [title] Bowden Tube Routing |
---|---|
+ | [* black] The Bowden tube is carried inside the mesh loom that holds the hot end wiring. |
+ | [* black] The PTFE will enter the mesh loom approximately 90mm below the extruder. Open a gap in the mesh by pressing two areas about 1" apart toward each other. This will expand the loom. |
+ | [* black] Insert the Bowden tube into this opening and thread it through the loom until it reaches a point about 225mm from the end of the hot end connector. |
+ | [* black] Open the loom as you did previously and thread the Bowden tube through the exit provided. |
Image 1
No previous image
Added
Image 2
No previous image
Added