| + | [title] Wiring the RAMBo Power Connector |
|---|
| + | [* black] Two pairs of 50mm long, 18ga red & black wires are required for this task. |
|---|
| + | [* black] Remove the insulation from the pre-stripped 50mm, 18ga red & black wires and insert them into the compression terminal at the locations shown. Fully tighten each connection! |
|---|
| + | [* black] Positions 5 and 6 also hold the 12ga red & black wires coming from the power supply. |
|---|
| + | [* black] The video linked below performs these steps in reverse order, which while more difficult to do...is entertaining to watch. :) |
|---|