Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Wiring the RAMBo Power Connector
[* black] Two pairs of 50mm long, 18ga red & black wires are required for this task.
[* black] Remove the insulation from the pre-stripped 50mm, 18ga red & black wires and insert them into the compression terminal at the locations shown. Fully tighten each connection!
-[* black] Positions 5 and 6 also hold the 12ga red & black wires coming from the power supply.
-[* black] The video linked below performs these steps in reverse order, which while more difficult to do...is entertaining to watch. :)
+[* black] Positions 5 and 6 also hold the 12ga red & black wires coming from the power supply. up the Y & Z towers

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added