Changes to Step #12
Step Lines
| + | [title] Preparing the Bed Thermistor Connector |
|---|---|
| + | [* black] Locate the thermistor leads that are included in the Rambo accessories bag. It's two white wires with a small 2 pin keyed connector on it. |
| + | [* black] Cut about 3" off the thermistor leads from the connector end. You'll be soldering this end to the thermistor leads that are coming out of the X tower. |
| + | [* black] Cut the remaining length of 1/8" diameter heat shrink in half. |
| + | [* black] Strip about 1/2" of insulation from each wire. |
| + | [* black] Slip one section of heat shrink over each wire and then solder them together. |
| + | [* black] Slide the heat shrink tubing over the exposed splice and shrink it using a lighter or heat gun. BE CAREFUL! |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added