Changes to Step #38

Edit by SeeMeCNC

Edit approved by SeeMeCNC


Step Lines

-[* black] H
+[title] Finishing Touches
+[* black] Tighten the strain relief nut on the bottom side of the top assembly
+[* black] Remove the paper backing from both sides of the acrylic panels.
+[* black] If you look at the injection molded base sides you will see the "stop" boss for the acrylic covers. Insert one side of the panel into the chosen corner, and then flex the panel into place.
+[* black] Repeat for the remaining corner covers.

Image 2

Old Version

New Version