Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #24

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Whip Connections on RAMBo
-[* black] We will now connect the whip to the RAMBo board.
+[* black] The whip connections specifically are noted below.
[* black] You should begin by connecting the red and black 18awg wires to a 2 position terminal block (found in RAMBo kit). Note the polarity in the photo.
[* black] Next, connect the orange wire to a 2 position terminal block (found in RAMBo kit). Note the polarity in the photo.
[* black] Next, connect the remaining wire to the board. These connection are pre-terminated and connect to the position noted in the pic.