| [* black] Insert 6-32 nylon lock nuts into the nut traps on the injection molded base sides. |
---|
| [* black] Install the first base side between the X & Z towers. |
---|
| [* black] Secure the base side with (2) 6-32 x 1" screws. |
---|
| [* black] Fasten the EZR Struder side plate to the base side plate using (2) 10-32 socket head cap screws. The holes in the injection molded side panels are not tapped / threaded. Make sure you put some pressure on the screws and keep them straight. |
---|
| [* black] Route the wires around the top assembly clockwise as before. You will route through the same locations as the other stepper motor wires. |
---|
| [* black] Plug the extruder stepper motor into the E0 location on the RAMBo board. |
---|