Changes to Step #5
Step Lines
[title] Insert Z Tower | |
[* black] The Z tower is the extrusion that has one black wire run through it. | |
[* black] Route the wire through the base top plate as shown. | |
[* black] Insert the extrusion into the base top plate, and then through each set of the TSLOT hardware. You will need to have the TSLOT nuts in a vertical orientation to be accepted by the extrusion. You also may need to loosen the TSLOT nuts if you have them too tight. | |
- | [* icon_caution] You should not force the extrusion into the assembly. |
[* black] Upon seating the extrusion, you should route the wires around the idler plate as shown and tighten the (4)1/4-20 button head screws. | |
[* black] Route the wire as shown. |