- | [* black] H |
---|
+ | [title] Insert Z Tower |
---|
+ | [* black] The Z tower is the extrusion that has one black wire run through it. |
---|
+ | [* black] Route the wire through the base top plate as shown. |
---|
+ | [* black] Insert the extrusion into the base top plate, and then through each set of the TSLOT hardware. You will need to have the TSLOT nuts in a vertical orientation to be accepted by the extrusion. You also may need to loosen the TSLOT nuts if you have them too tight. |
---|
+ | [* icon_caution] You should not force the extrusion into the assembly. |
---|
+ | [* black] Upon seating the extrusion, you should route the wires around the idler plate as shown and tighten the (4)1/4-20 button head screws. |
---|
+ | [* black] Route the wire as shown. |
---|