Changes to Step #4

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] H
+[title] Insert Y Tower
+[* black] The Y tower is the extrusion that has one red wire run through it.
+[* black] Route the wire through the base top plate as shown.
+[* black] Insert the extrusion into the base top plate, and then through each set of the TSLOT hardware. You will need to have the TSLOT nuts in a vertical orientation to be accepted by the extrusion. You also may need to loosen the TSLOT nuts if you have them too tight.
+[* icon_caution] You should not force the extrusion into the assembly.
+[* black] Upon seating the extrusion, you should route the wires around the idler plate as shown and tighten the (4)1/4-20 button head screws.
+[* black] Route the wire as shown.