Changes to Step #2
Edit by Matthew Connor —
Edit approved by Matthew Connor
- Before
- After
- Unchanged
Step Lines
| [title] Insert X Tower | |
| - | [* black] The X tower is the extrusion that has the white and black wires |
| + | [* black] The X tower is the extrusion that has the white and black wires running through it. |
| [* black] Route the wires through the top base plate as shown. | |
| [* black] Insert the extrusion into the base top plate, and then through each set of the TSLOT hardware. You will need to have the TSLOT nuts in a vertical orientation to be accepted by the extrusion. You also may need to loosen the TSLOT nuts if you have them too tight. | |
| [* icon_caution] You should not force the extrusion into the assembly. Be extremely careful while working the extrusion down into the plate and through the TSLOT hardware. Too much side-to-side motion can easily fracture the base plate, which is made of pressboard. | |
| [* black] Upon seating the extrusion, you should route the wires around the idler plate as shown and tighten the (4)1/4-20 button head screws. |