Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Matthew Connor

Edit approved by Matthew Connor

Before
After
Unchanged

Step Lines

[title] Insert X Tower
[* black] The X tower is the extrusion that has the white and black wires run through it.
-[* black] Route the wires through the base top plate as shown.
+[* black] Route the wires through the top base plate as shown.
[* black] Insert the extrusion into the base top plate, and then through each set of the TSLOT hardware. You will need to have the TSLOT nuts in a vertical orientation to be accepted by the extrusion. You also may need to loosen the TSLOT nuts if you have them too tight.
-[* icon_caution] You should not force the extrusion into the assembly.
+[* icon_caution] You should not force the extrusion into the assembly. Be extremely careful while working the extrusion down into the plate and through the TSLOT hardware. Too much side-to-side motion can easily fracture the base plate, which is made of pressboard.
[* black] Upon seating the extrusion, you should route the wires around the idler plate as shown and tighten the (4)1/4-20 button head screws.