Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] H
+[title] Plug In the End Stop Wires
+[* black] Plug the end stop wires in the correct locations on the RAMBo board in the MAX locations. Ensure that you get the correct X Y Z locations.
+[* black] In the image, X = Red Y = Blue Z = Magenta. The red line is covering the MIN end stop location that are not used.
+[* black] Secure the end stop wires with an additional zip tie if desired.

Image 1

Old Version

New Version

Image 2

Old Version

New Version