Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #12

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Installing Board Supports and RAMBo Fan
[* black] Locate the (4) Board Supports and (4) #6 x 1/2" screws indicated in the image. These are located in hardware pack #84489
[* black] Attach the board supports to the top base plate in the locations shown.
[* black] Attach the fan that you prepared in the previous step to the top base plate using (2) zip ties as shown. Note the correct orientation of the fan. The label will be facing up.
+[* black] The fan has a directional arrow on the side, showing the flow of air. It should be installed so it will blow up at the RAMBo (when installed)