Changes to Step #37
Step Lines
| + | [title] Final Review of RAMBo Wiring Connections |
|---|---|
| + | [* black] Use the image to the left to perform a final check of your wiring connections. All connections are outlined, and these connections must be made in order for the printer to be functional with the HE280 Hotend. |
| + | [* icon_note] NOTE: You may need to wait to connect the Endstops and Stepper Motors until you have installed the RAMBo in the base of your printer. |
| + | [* black] HE280 power (2 position terminal block with 1 red 18awg & 1 black 18awg wire) goes to Heat 0 terminal ------------- HE280 thermistor (2 position latching connector with 1 white 26awg & 1 green 26awg wire) goes to the T0 position on the RAMBo board |
| + | [* black] Layer Fan power (2 position terminal block with 1 orange 26awg wire (-)) goes to Fan 0 |
| + | [* black] Heated bed power (2 Position terminal block with 1 black wire) goes to the Heat2-Bed (-) terminal ---------- Heated bed thermistor (2 position latching connector with 2 white wires) goes to the T2 position on the RAMBo board |
| + | [* black] PS-ON (2 position latching connector with 1 blue 26awg wire) goes to the PS-ON position on the RAMBo board |
| + | [* black] i2c (4 position latching connector with 1 red & 1 black 26awg wire) goes to the i2c position on the RAMBo board |
| + | [* black] Stepper motors connect to stepper motor drivers, labelled X Y Z & E0 ---------- Endstops connect to X Y Z max endstop inputs ---------- 40mm fan connects to 12v AUX output ---------- 12v (6 position terminal block with red and black wires) connects to VIN input on the RAMBo Board |
Image 1
No previous image
Added