| - | [* black] Insert wisdom here. |
|---|
| + | [title] Installing the Bowden Tube |
|---|
| + | [* black] Work the bowden tube up through the mesh loom. It will exit the mesh loom approximately 90mm from the bottom face of the PTC adapter. |
|---|
| + | [* icon_note] If you have the EZStruder, that would be 90mm from the end of the brass PTC connector (grey or blue ring). |
|---|
| + | [* icon_note] If you have the EZR Struder that would be 90mm from the end of the cartridge PTC adapter (black ring) |
|---|
| + | [* black] Keep sliding the bowden tube up through the mesh loom until it is approximately 40mm from the end of the 8 position pluggable connector. |
|---|