Skip to main content

Changes to Step #45

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[title] Installing the Bowden Tube
+[* black] The bowden tube gets installed approximately 90mm from the end of the hot end whip. Measure from the end of the 8 position pluggable connector.
+[* black] You want to insert the bowden tube into the mesh loom on the same side of the connector that has the beveled edges. This is noted in the picture with red makers.

Image 2

Old Version

New Version