Skip to main content

Changes to Step #19

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[title] 18awg Wire Connections
+[* black] Locate the 18awg wires from the existing wiring (in most instances these wires are red and black) and the new hotend whip.
+[* black] The connections will be red to red, black to black. (If you have wires that are other than red/black for your existing 18awg wires, you will need determine which is positive and negative. These are the Heat 0 wire from the RAMBo)
+[* black] Slide a piece of heat-shrink tubing over one of the red wires and one of the black wires.