Skip to main content

Changes to Step #11

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[title] I2C wires
+[* black] Cut 2 pieces of heat-shrink at 15mm each. (This was included with the hot end whip)
+[* black] Slide a 15mm long heat-shrink tubing over the red wire that is in the 4 pin latching housing. (as shown in the picture)
+[* black] Slide a 15mm long heat-shrink tubing over the black wire that is in the 4 pin latching housing. (as shown in the picture)
+[* black] Perform an in-line splice of the wires, Red to Red, Black to Black.
+[* black] Solder the connections.