Skip to main content

Changes to Step #10

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[title] Preparing the Next Connection
+[* black] Remove the wires from the Heat 0 - & + terminal.
+[* black] Locate the Red and Black 26awg wire that you cut from the Hotend Whip. These wires are already inserted into a 4 pin latching housing.
+[* black] Strip approximately 10-15mm of insulation off of the black and red wires (with that are in the 4 pin latching housing).
+[* black] Strip approximately 10-15mm of insulation off of the wires that were previously in the Heat 0 - & + locations.