| - | [* black] Insert wisdom here. |
|---|
| + | [title] Preparing the Hotend Whip |
|---|
| + | [* black] If you purchased the Hotend Whip from SeeMeCNC, it is fully assembled. For upgrading Rostock machines, it will require some modification. |
|---|
| + | [* icon_note] One end of the whip has an 8 pin pluggable connector, the other end has (2) 2 pin connectors & (1) 4 pin connector. |
|---|
| + | [* black] On the side that has (2) 2 pin connectors & (1) 4 pin connector, measure and cut all 8 of these leads approximately 125mm from the end. (they are cut slightly longer in the picture) |
|---|