Skip to main content

Changes to Step #7

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[title] Preparing the First Connection
+[* black] If your Fan 0 wires are knotted (like the ones here) and there is not enough excess room to work with the + wire, take a minute and get those wires separated.
+[* black] Locate the BLUE 26awg wire that you cut from the Hotend Whip. This wire is already inserted into a 2 pin latching housing.
+[* black] Strip approximately 10-15mm of insulation off of the blue wire.
+[* black] Strip approximately 10-15mm of insulation off of the wire that was previously in the Fan 0 + location.