Skip to main content

Changes to Step #6

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[title] Removing the RAMBo Board
+[* black] The RAMBo board is mounted to a backer board. You will grasp that backer board on the bottom left and right pull out. The bottom of the RAMBo (and backer) should pull freely and tip out. Once the top ears on the backer board have cleared the top plate of the base, the entire board can be removed.
+[* black] Remove the 6 pin pluggable terminal block from the RAMBo board. (This terminal block has the wires that come from the power supply)
+[* black] Loosen and remove ***ONLY*** the wire from the Fan 0 + terminal on the top of the RAMBo board.

Image 3

Old Version

New Version