Changes to Step #8
Edit by Matthew Connor —
Edit declined by SeeMeCNC
- Before
- After
- Unchanged
Step Lines
| [title] Final Assembly | |
| [* black] Install the stepper motor handwheel by aligning the flat of the molded handwheel with the flat of the stepper motor shaft and pressing down until it bottoms out. | |
| [* icon_note] The stepper motor handwheel is used for manually advancing / retracting filament. | |
| - | [* black] If this is going to be installed in a new build install the (2) 6-32 x 1" machine screws and lock-nuts in the remaining 2 holes in the EZR Struder plates and ***hand tighten only*** |
| - | [* icon_note] HAND-TIGHTEN ONLY. These are being placed here for safekeeping only. |
| - | [* black] If you are upgrading a printer and ready to install, you will now install the EZR Struder using the (2) 6-32 x 1" machine screws and Nylon lock-nuts to mount your EZR Struder into you extruder mount. |
| + | [* black] If this is going to be installed in a new build, install the two 6-32 x 1" machine screws and lock-nuts in the remaining 2 holes in the EZR Struder plates and ***++HAND TIGHTEN ONLY++***. |
| + | [* black] If you are upgrading a printer and ready to install, you will now install the EZR Struder using the two 6-32 x 1" machine screws and Nylon lock-nuts to mount your EZR Struder into your extruder mount. |
| [* icon_note] The black lanyard clips are installed once the bowden tube is installed in the EZR Struder. We send plenty of extra in case you ever lose one. |