Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by SeeMeCNC

Edit approved by SeeMeCNC


Step Lines

-[* black] J
+[title] Final Assembly
+[* black] Install the stepper motor handwheel by aligning the flat of the molded handwheel with the flat of the stepper motor shaft and pressing down until it bottoms out.
+[* icon_note] The stepper motor handwheel is used for manually advancing / retracting filament.
+[* black] If this is going to be installed in a new build install the (2) 6-32 x 1" machine screws and lock-nuts in the remaining 2 holes in the EZR Struder plates and ***hand tighten only***
+ [* icon_note] HAND-TIGHTEN ONLY. These are being placed here for safekeeping only.
+[* black] If you are upgrading a printer and ready to install, you will now install the EZR Struder using the (2) 6-32 x 1" machine screws and Nylon lock-nuts to mount your EZR Struder into you extruder mount.
+ [* icon_note] The black lanyard clips are installed once the bowden tube is installed in the EZR Struder. We send plenty of extra in case you ever lose one.