| + | [title] Marking the Panel |
|---|
| + | [* black] From the template that you printed, cut the drawing of the side panel out. |
|---|
| + | [* black] Poke holes in the two location where the thumb screws go. |
|---|
| + | [* black] Lay the template on the side panel and insert the thumb screws to keep the template aligned. |
|---|
| + | [* black] Marking Method #1 - If your machine is white you can use a sharpie marker to mark the points. Press the marker in the center of the center marks for the 4 screw locations. This will allow the marker the bleed through and mark the locations. |
|---|
| + | [* black] Marking Method #2 - If your machine is black you may find it easier to use a pin, or other sharp point to mark the locations of the centers of the holes. |
|---|