Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #5

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Change Hot End Adapter
[* black] Remove the hot end from the old-style platform and install it into the new style.
[* black] Tie the wires to the strain relief using a 4" wire tie in the notch shown.
[* black] Install the hot end on to the new platform.
-[* black] This new arm upgrade as significantly changed the geometry of the printer. Because of this, you'll need to recalibrate. In order to do this successfully, you'll need to change your Horizontal Radius to 140 (if you haven't already) and the Diagonal Rod length to 290.8.
+[* black] This new arm upgrade has significantly changed the geometry of the printer. Because of this, you'll need to recalibrate. In order to do this successfully, you'll need to change your Horizontal Radius to 140 (if you haven't already) and the Diagonal Rod length to 290.8.
[* black] Once you've recalibrated the printer, move on to the next step.