Changes to Step #190
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
+ | [title] Install PTFE |
---|---|
[* black] Insert the loop of the lanyard over the top PTFE tube as shown in Pic 1. | |
[* black] Insert the PTFE tube into the extruder fully till it stops near the hobbed drive gear as shown in Pic 2. | |
[* black] Insert the clip side of the lanyard under the black clip of the PTC connector on the ezr struder as shown in Pic 3. | |
[* black] After the lanyard is installed in the PTC connector, give the PTFE tube a strong push further into the ezr struder to fully seat it. |