Changes to Step #164
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* black] Insert wisdom here. |
---|---|
+ | [* black] We will now be assembling the top plate. You will need to gather the top sheet metal plate, 4 silver build plate clamps, 4 large 1" od plastic washers, 4x 6-32 x 1/2" long flat head phillips screws, and 4 nylon lock nuts. |
+ | [* icon_caution] Note the orientation of the top plate in Pic 1. This is the top of the plate. The orientation is important. |
+ | [* black] Insert the screws through the build plate clamps and into the sheet metal. |
+ | [* black] On the underside put the washer through the screw and insert the nylon lock nut to secure it in place. |
+ | [* black] Do not fully tighten the bulid plate clamps so you can still twist them. Tighten the nylon lock nuts snug but not fully tight. |