Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #161

Edit by Tim Koscielny

Edit approved by Tim Koscielny

Before
After
Unchanged

Step Lines

[title] Install Extruder
[* black] Using a small section of filament, test to make sure holding down the red lever you can easily pass the filament through the ezr struder.
[* black] Release the red lever and make sure the filament is being held tightly by the hobbed gear.
-[* black] If you purchased the dual extruder kit, now would be a good time to install the second extruder the same way as this one.
+[* icon_caution] If you purchased the dual extruder kit, now would be a good time to install the [guide|131|second extruder] the same way as this one.