Changes to Step #161
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
+ | [title] Install Extruder |
---|---|
[* black] Using a small section of filament, test to make sure holding down the red lever you can easily pass the filament through the ezr struder. | |
[* black] Release the red lever and make sure the filament is being held tightly by the hobbed gear. | |
[* black] If you purchased the dual extruder kit, now would be a good time to install the second extruder the same way as this one. |