Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #161

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] Using a piece of filament to check passthrough and grab
+[* black] Using a small section of filament, test to make sure holding down the red lever you can easily pass the filament through the ezr struder.
+[* black] Release the red lever and make sure the filament is being held tightly by the hobbed gear.
+[* black] If you purchased the dual extruder kit, now would be a good time to install the second extruder the same way as this one.