Changes to Step #159
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* black] Insert wisdom here. |
---|---|
+ | [* black] Using the 6-32 x 7/8" long screws, insert them in the two upper holes of the ezr struder. |
+ | [* black] These screws will not go into the motor, but through the ezr struder and through the extruder bracket. |
+ | [* black] Use the nylon lock nuts to secure the screws and tighten the ezr struder to the extruder plate as seen in Pic 3. |